Comparative study between heat pipe and shell-and-tube thermal energy storage

Thumbnail Image
Maldonado, José MiguelMaldonado, José Miguel - ORCID ID
Vérez, DavidVérez, David - ORCID ID
Gracia Cuesta, Alvaro deGracia Cuesta, Alvaro de - ORCID ID
Cabeza, Luisa F.Cabeza, Luisa F. - ORCID ID
Other authors
cc-by (c) Maldonado et al., 2021
Journal Title
Journal ISSN
Volume Title
This paper experimentally evaluates the implementation of heat pipes in latent heat thermal energy storage systems. The well-known performance of heat pipes as a heat transfer technology makes them great candidates to be used as heat exchangers. However, previous studies compared their efficacy against solid metal rods, where heat pipes clearly succeeded. Therefore, the objective of this study is to experimentally evaluate the advantages of using heat pipes instead of a common shell and tubes system, during charging processes. In particular, five latent heat thermal energy storage systems were tested. One based on the shell and tubes, and the remaining four based on heat pipes. The experiments were conducted at constant heat transfer fluid temperature and flow rate, and the results were analysed from the temperature, heat transfer, and visual point of view. The results show that in heat pipes systems the phase change material melts homogeneously through all the storage container. However, the shell and tubes tank performed the charging process in 25 min while the fastest heat pipe one took 40 min for it. On the other hand, in the shell and tubes configuration melt from the heat transfer fluid inlet towards the outlet. Moreover, systems with more heat pipe surface inside the heat transfer fluid collector rovided higher power rates. Comparing the best and the worst heat pipe storage tanks during the first 30 min, the heat transfer rate increased over 40%. But the storing material low conductivity cushioned those high heat transfer rates.
Journal or Serie
Applied Thermal Engineering, 2021, vol. 192, p. 116974-1-116974-11