Effect of a longitudinal cut on the mechanical properties of small-diameter roundwood of Pinus nigra Arnold
Data de publicació2016
Fernandez Serrano, Alvaro
Puigdomènech Franquesa, Lluís
Moliner Gil, David
MetadadesMostra el registre d'unitat complet
The use of roundwood in structures has drawbacks that include tapering and lack of flatness, which can be overcome by making a longitudinal cut to flatten one side. The aim of this work was to compare the mechanical behavior of roundwood vs. roundwood with one flat face, comparing pieces of small-diameter
roundwood from young trees of Pinus nigra Arnold. Half the samples were given a longitudinal cut. Specimens taken from these pieces were tested for bending and compression parallel to the grain to determine their modulus of elasticity and strength. The modulus of rupture by bending was 22% lower in roundwood with one flat face (59.0 MPa) than in roundwood (75.6 MPa). It has been observed that the smaller cross section in the roundwood with one flat face is not the only explanation for the decrease in the bending strength. In contrast, no significant differences were observed for the other three mechanical properties studied (compression strength parallel to the grain and modulus of elasticity in bending and compression).
És part deBioresources, 2016, vol. 11, núm. 2, p. 3587-3597
Mostrant elements relacionats per títol, autor i matèria.
Effect of vacuum and pressure treatments on the mechanical properties and moisture balance of wood from Pinus sylvestris Villasante Plágaro, Antonio M.; Laina, Ruben; Vignote, Santiago (North Carolina State University, 2016)Several works have analyzed the alteration in the mechanical strength of wood after the application of protective substances. However, it remains unclear whether the significant differences obtained are caused by the ...
Mechanical properties of wood from Pinus sylvestris L. treated with Light Organic Solvent Preservative and with waterbone Copper Azole Villasante Plágaro, Antonio M.; Laina, Ruben; Rojas, J. A. M.; Rojas, I. M.; Vignote, Santiago (INIA, 2013)Aim of study: To determine the effect on wood from Pinus sylvestris of treatment with preservatives on mechanical properties and to establish the relation between the penetration and compression strenght. Area of study: ...
Rodríguez Puerta, Francisco; Villasante Plágaro, Antonio M. (Asociación de investigación técnica de las industrias de la madera (AITIM), 1998)Se resume el estudio realizado en el Departamento de Ingeniería Agroforestal de la Universidad de Lleida sobre las propiedades de hinchazón y merma de la especie Pinus uncinata Ram. Para ello se realizó un muestreo ...