Variable rate sprayer. Part 1 – Orchard prototype: design, implementation and validation
Data de publicació2013
Gil Moya, Emilio
MetadadesMostra el registre d'unitat complet
Discussions in recent decades about dosage models for applying plant protection products in orchards have failed to reach a compromise solution. Furthermore, canopies are spatially variable, and a uniform dose may not be adequate for the entire orchard. Spraying at an adequate volume application rate on a site-specific basis would help reduce the amount of agrochemicals used in the framework of precision horticulture and precision fructiculture. An orchard sprayer prototype running a variable-rate algorithm to adapt the volume application rate to the canopy volume in orchards on a real-time and continuous basis was designed, implemented, and validated. An equivalent prototype was designed for vineyards and described in a companion paper (‘Variable rate sprayer. Part 2 – Vineyard prototype: Design, implementation and validation’). The orchard prototype was divided into three parts: the canopy characterization system (using a LiDAR sensor), the controller executing a variable-rate algorithm, and the actuators. The controller determines the intended flow rate by using an application coefficient (required liquid volume per unit canopy volume) to convert canopy volume into a flow rate. The sprayed flow rates are adjusted via electromagnetic variable-rate valves. The goal of the prototype was to keep the actual application coefficients as close as possible to the objective. Strong relationships were observed between the intended and the sprayed flow rates (R2 = 0.935) and between the canopy cross-sectional areas and the sprayed flow rates (R2 = 0.926). In addition, when spraying in variable-rate mode, the prototype achieved significantly closer application coefficient values to the objective than those obtained in conventional spraying application mode.
És part deComputers and Electronics in Agriculture, 2013, vol. 95, p. 122-135
Projectes de recerca europeus
Mostrant elements relacionats per títol, autor i matèria.
Escolà i Agustí, Alexandre; Planas de Martí, Santiago; Rosell Polo, Joan Ramon; Pomar Gomà, Jesús; Camp, Ferran; Solanelles Batlle, Francesc; Gràcia, Felip; Llorens Calveras, Jordi; Gil Moya, Emilio (Molecular Diversity Preservation International (MDPI), 2011)Electronic canopy characterization is an important issue in tree crop management. Ultrasonic and optical sensors are the most used for this purpose. The objective of this work was to assess the performance of an ultrasonic ...
Obtaining the three-dimensional structure of tree orchards from remote 2D terrestrial LIDAR scanning Rosell Polo, Joan Ramon; Llorens Calveras, Jordi; Sanz Cortiella, Ricardo; Arnó Satorra, Jaume; Ribes Dasi, Manuel; Masip Vilalta, Joan; Escolà i Agustí, Alexandre; Camp, Ferran; Solanelles Batlle, Francesc; Gràcia, Felip; Gil Moya, Emilio; Val, Luis; Planas de Martí, Santiago; Palacín Roca, Jordi (Elsevier, 2009)In recent years, LIDAR (light detection and ranging) sensors have been widely used to measure environmental parameters such as the structural characteristics of trees, crops and forests. Knowledge of the structural ...
Sanz Cortiella, Ricardo; Llorens Calveras, Jordi; Escolà i Agustí, Alexandre; Arnó Satorra, Jaume; Ribes Dasi, Manuel; Masip Vilalta, Joan; Camp, Ferran; Gràcia Aguilà, Felipe José; Solanelles Batlle, Francesc; Planas de Martí, Santiago; Pallejà Cabrè, Tomàs; Palacín Roca, Jordi; Gregorio López, Eduard; Del Moral Martínez, Ignacio; Rosell Polo, Joan Ramon (Molecular Diversity Preservation International (MDPI), 2011)In this work, a LIDAR-based 3D Dynamic Measurement System is presented and evaluated for the geometric characterization of tree crops. Using this measurement system, trees were scanned from two opposing sides to obtain two ...